TCP Builder › Plan library

Traffic Control Plan Library

Every scenario the builder supports, worked out for every state, with the MUTCD numbers computed by the same engine that draws the sheet. Pick your state and your setup, or skip straight to the builder.

Real MUTCD dimensions, a title block, and a printable sheet — no account, no cost.

Build this plan free — takes about 2 minutes

Shoulder Closure plans

Work on the shoulder, traffic stays in its lanes — you taper cones onto the shoulder and post advance warning, but nobody changes lanes.

Flagger Lane Closure plans

One lane is closed and flaggers alternate the two directions through the single open lane, one way at a time.

Multilane Lane Closure plans

Close one lane of a 4+ lane road; traffic merges past on the remaining lanes behind a taper and arrow board.

Full Closure Detour plans

The road is closed to through traffic and everyone is routed around the work on a signed detour.

DISCLAIMER — READ BEFORE USE

This traffic control plan was generated by an automated tool for planning and reference purposes only. It is based on the MUTCD 11th Edition Part 6 typical applications and the agency rule set selected above. It is not a certified, sealed, or professionally engineered document and has not been reviewed against actual field conditions at this site. It must be reviewed, adapted to field conditions, and approved by a qualified person — and, where required, by the permitting agency and/or a licensed Professional Engineer — before use. Field conditions govern. The user is solely responsible for work-zone safety, for conformance with all applicable federal, state, and local requirements, and for obtaining all required permits. PM Axsus disclaims all liability arising from use of this document.